It's that easy:

3D foil-lamination and foil-coating:

Pre-heat unit to desired operation temperature
Insert work pieces including supporting pads
Spread the 3D foil over the work piece surface and close the heating cover
After the preset heat-up time, initiate the vacuum pressing procedure (duration of pressing cycle: approx. 100 – 150 seconds)
After the pressing cycle has been completed, lift the heating cover and extract the finished work pieces
Continue on to no. 2 below

Layer-gluing and form-veneering:

If needed, attach the heating cover, and set it to the desired temperature (note that a 20 minute pre-heating time is required. Keep the heating cover closed during the pressing cycle and while you insert work pieces. This helps to save energy.)
Adjust the operation surface into the desired position
Open the membrane frame and insert the work piece
always leave some space between the work piece and the inside of the frame (at least one time the height of the work piece)
Close the membrane frame
Turn on the vacuum pump to inititate the air-extraction process and to begin the pressing cycle
Once the desired ultimate pressure has been reached, the pump will automatically turn on and off as needed (this saves energy)
After completion of the pressing cycle, turn off the unit, open the membrane frame, and extract the finished work piece