Um die Bilder und Videos sehen zu können benötigen sie: - FlashPlayer - JavaScript muss aktiviert sein!

It’s that easy:

3D foil-lamination and foil-coating:

• Pre-heat unit to desired operation temperature (approximately 25 minutes)
• Insert work pieces including supporting pads
• Spread the 3D foil over the work piece surface and close the heating cover
• After the preset heat-up time, initiate the vacuum pressing procedure (duration of pressing cycle: approx. 100 – 150 seconds)
• After the pressing cycle has been completed, lift the heating cover and extract the finished work pieces
• Continue on to no. 2 below

Layer-gluing and form-veneering:

• If needed, attach the heating cover, and set it to the desired temperature (note that a 20 minute pre-heating time is required. Keep the heating cover closed during the pressing cycle and while you insert work pieces. This helps to save energy.)
• Adjust the operation surface into the desired position
• Open the membrane frame and insert the work piece
• ATTENTION: always leave some space between the work piece and the inside of the frame (at least 1.5 times the height of the work piece)
• Close the membrane frame
• Turn on the vacuum pump to inititate the air-extraction process and to begin the pressing cycle
• Once the desired ultimate pressure has been reached, the pump will automatically turn on and off as needed (this saves energy)
• After completion of the pressing cycle, turn off the unit, open the membrane frame, and extract the finished work piece