vacuum3.jpg
  • Performer
    Performer
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Combitherm
    Combitherm
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Combimat
    Combimat
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Vacuform
    Vacuform
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Vacuplus
    Vacuplus
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Vacufix
    Vacufix
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Multimat
    Multimat
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Ecomat
    Ecomat
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Profitherm
    Profitherm
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Vacuflex
    Vacuflex
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Vacustar
    Vacustar
    Wood and materials such as
    Thermoplastic materials
    3D-foil laminating of PVC
  • Vacucaddy
    Vacucaddy

It's that easy...


3D foil-lamination and foil-coating:

  • Pre-heat unit to desired operation temperature
  • Insert work pieces including supporting pads
  • Spread the 3D foil over the work piece surface and close the heating cover
  • After the preset heat-up time, initiate the vacuum pressing procedure (duration of pressing cycle: approx. 100 – 150 seconds)
  • After the pressing cycle has been completed, lift the heating cover and extract the finished work pieces
  • Continue on to no. 2 below

Layer-gluing and form-veneering:

  • If needed, attach the heating cover, and set it to the desired temperature (note that a 20 minute pre-heating time is required. Keep the heating cover closed during the pressing cycle and while you insert work pieces. This helps to save energy.)
  • Adjust the operation surface into the desired position
  • Open the membrane frame and insert the work piece
  • always leave some space between the work piece and the inside of the frame (at least one time the height of the work piece)
  • Close the membrane frame
  • Turn on the vacuum pump to inititate the air-extraction process and to begin the pressing cycle
  • Once the desired ultimate pressure has been reached, the pump will automatically turn on and off as needed (this saves energy)
  • After completion of the pressing cycle, turn off the unit, open the membrane frame, and extract the finished work piece

Get Prices

We guarantuee that your input data will be treated confidentially, and that it will not be shared with third parties. With sending off the form, you agree that we save and use your personal details.
All requested information is provided free of charge, and does not oblige you to make a purchase.
Logo Austria